Land Pride AFM4214 Operator's Manual page 29

Section 2: Adjustments
Linchpin
Insert From the Front
C-Spacers
Approximately 3/4" (1.9 cm)
Minimum Cutting Height Set-up
No Spacers Located Below Wheel Spindle Tube
IMPORTANT: Linchpins should always be inserted
into the gauge wheel spindle from the front with the
locking clasp flipped shut over the spindle toward the
back. Attaching the pin in this manner will prevent
vegetation from catching on the clasp and flipping it
open while traveling forward.
6. After making height adjustments, always replace
linchpins by inserting them into the gauge wheel
spindle pin holes from the front to keep from loosing
the pins and gauge wheels.
7. Lower mower decks to the field position making sure
all fold cylinders are fully extended.
Refer to Figure 2-5:
IMPORTANT: Slide-on spacers are 1/2" thick. Use
two 1/2" slide-on spacers at the front of the rear deck
for every 1" spacer used at the back of the rear deck.
8. Adjust front of center deck height to match height at
rear of center deck:
a. Attach jack stand to jack mount located in front of
the center gearbox channel. Make sure stand is
secured with attachment pin.
b. Screw jack out to lift front of mower deck and in to
lower deck front.
c. Place same number and thickness of C-spacers
below the spindle tube as what was placed below
the rear gauge wheel spindle tubes.
d. There is a groove in the carrier rod for adding or
removing C-spacers. Turn the C-spacer so that
the open end will slide in or off the groove as
needed.
e. Remove jack stand and return it to the storage
tube located in front of the divider gearbox.
f. Place additional C-spacers above metal spindle
tubes.
11/19/21
Table of Contents
Gauge Wheel Spacers
Insert From the Front
Spindle Tube
12717
Figure 2-4
9. Take measurements at the same location on all three
decks to verify they are all at the same cutting height.
10. Additional fine tuning adjustments may be needed
after a test mowing run.
19034
C-Spacers
Groove on Rod
to Add or Remove
C-Spacers
Some mower items not shown for clarity
AFM4214 and AFM4216 All-Flex Grooming Mowers 315-587M
Linchpin
C-Spacers
Approximately 5 1/4" (13.3 cm)
Maximum Cutting Height Set-up
All Spacers Located Below Wheel Spindle Tube
Additional C-Spacers on Top
Screw Jack
Adding or Replacing Spacers
Figure 2-5
Spindle Tube
Gauge Wheel
Spacers
12716
Jack Mount
25