General Safety Rules For Bench Top Tools - Skil 3540 Owner's Manual

WARNING

GENERAL SAFETY RULES FOR BENCH TOP TOOLS

Work Area
Keep work area clean and well lit. Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or
fumes.
Keep bystanders, children and visitors away while operating a power tool. Distractions
can cause you to lose control.
Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
Do not leave tool running unattended, turn power off. Do not leave tool until it comes to a
complete stop.
MAKE WORKSHOP CHILDPROOF with padlock, master switches, or by removing starter keys.
Electrical Safety
Before plugging in the tool, be certain the outlet voltage supplied is compatible with
the voltage marked on the nameplate within 10%. An outlet voltage incompatible with that
specified on the nameplate can result in serious hazards and damage to the tool.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges and
refrigerators . There is an increased risk of electric shock if your body is grounded.
Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an
outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace damaged
cords immediately. Damaged cords increase the risk of electric shock.
Only use an outdoor extension cord marked "W-A" or "W". These cords are rated for
outdoor use and reduce the risk of electric shock.
Personal Safety
Stay alert, watch what you are doing and use common sense when operating a power
tool . A moment of inattention or use of drugs, alcohol or medication while operating power
tools can be dangerous.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your
hair, clothing and gloves away from moving parts. Loose clothes, jewelry or long hair
can be caught in moving parts. Roll long sleeves above elbows. Rubber gloves and nonskid
footwear are recommended when working outdoors.
Avoid accidental starting. Be sure switch is "OFF" before plugging in. Carrying tools with
your finger on the switch or plugging in tools that have the switch "ON" invites accidents.
Remove adjusting keys or wrenches before turning the tool "ON". A wrench or a key that
is left attached to a rotating part of the tool will be thrown.
Do not overreach, keep proper footing and balance at all times. Proper footing and
balance enables better control of the tool in unexpected situations.
Do not stand on tool or its stand. Serious injury may occur if the tool is tipped or if the
cutting tool is accidentally contacted. Do not store materials on or near the tool such that it is
necessary to stand on the tool or its stand to reach them.
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES listed
BELOW and other safety precautions, may result in serious personal injury.
3