Kidde Gemini II Design, Installation, Operation, And Maintenance Manual page 109

GENERAL RELEASING NOTES:
1. TO GUARANTEE THE REQUIRED VOLTAGE AT THE RELEASING DEVICE, THE FOLLOWING TABLE SHALL BE USED.
EX: TO DETERMINE THE TOTAL LOOP LENGTH, MEASURE THE DISTANCE BETWEEN THE CONTROL HEAD AND THE
CONTROL PANEL TERMINAL BLOCK, THEN MULTIPLY BY TWO.
DEVICE
RELEASING
2. RELEASING OUTPUT DEVICES SPECIFICATION
DEVICE
890181
899175
48650001
81-100000-001
FM
SOLENOID
GROUP
- FOR SUPERVISED CIRCUITS
S
3.
- FOR POWER LIMITED CIRCUITS
L
4. The following releasing device configurations are possible:
(1)One Kidde Solenoid Control Head wired to Release terminals R2-/R1+.
(2) One Kidde Solenoid Control Head wired to Release terminals R1-/R1+ and R2-/R2+ respectively.
(3) One Kidde Solenoid Control Head wired to Release terminals R2-/R1+ plus one Kidde Solenoid
Control Head wired to Stop Valve terminals Stop V-/Stop V+.
(4) Two Kidde Solenoid Control Heads wired to Release terminals R1-/R1+ and R2-/R2+ respectively
plus one Kidde Solenoid Control Head wired to Stop Valve terminals Stop V-/Stop V+.
(5) One FM Deluge/Pre-Action solenois wired to Release terminals R2-/R1+.
(6) One Kidde Solenoid Control Head wired to Release terminals R2-/R1+ plus one FM Deluge/
Pre-Action solenois wired to Stop Valve terminals Stop V-/Stoop V+.
November 2002
SOLENOID
PART NO.
890181
899175
48650001
81-100000-001
A
FM
B,D
SOLENOID
E,G
GROUP
MAXIMUM OF ONE #12 AWG WIRE PER TERMINAL.
I max.
2.4 A
2.4 A
240 mA
440 mA
A 458 mA
B,D 700 mA
E,G 420 mA
Figure E-7 (con't.) Release Circuit and Stop Valve Terminal Detail
firealarmresources.com
WIRE LENGTH (FT.)
12 AWG 14 AWG 16 AWG
300 200 120
300 200 120
3000 2000 1200
2300 1460 915
1440 760 480
940 500 300
1570 760 525
RESISTANCE (min.)
10 OHM
10.8 OHM
103 OHM
59 OHM
52 OHM
34 OHM
57 OHM
E-7
Kidde Gemini II System
18 AWG
800
570
340
220
370
"ON" TIME
MOMENTARY
MOMENTARY
CONTINUOUS
CONTINUOUS
CONTINUOUS
CONTINUOUS
CONTINUOUS
06-235975-001