Cub Cadet C21 769-10224C Manual page 23

Maintenance
Starting the device
Observe the servicing instructions in the engine
Î
manual.
At the end of the season, have the mower in-
Î
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Hand over used batteries to your dealer or to
a waste management company. Remove the
battery before scrapping the mower.
Using jump leads
Risk of explosion / short-circuit
¾ Never bypass a defective or frozen
battery with jump leads.
¾ Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive terminal
Î
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Connect the black jump lead first to the negative
Î
terminal (–) of the donor battery.
Connect the other clip to the frame of the engine
Î
block of the device as far away from the battery as
possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the device.
Î
Switch the parking brake on.
Î
Disconnect the jump leads in reverse sequence.
Î
DANGER !
Tyre pressure
WARNING !
Increased tyre pressure
ÂRisk of accident and damage to the
device
¾ Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where
Î
necessary.
Note
Excessive tyre pressure reduces the service
life of the tyres. Check the tyre pressure
prior to every instance of use.
After 5 operating hours
Perform the first engine oil change (for intervals
Î
refer to the engine manual).
Use the quick oil drain (optional) to drain the
Î
oil Q .
Note
When draining the oil, use a suitable collec-
tion container.
After 10 operating hours
Lubricate all rotating and bearing points of the ac-
Î
celerator pedal and brake pedal with a few drops
of light oil.
Clean the battery poles and terminals.
Î
Every 25 operating hours
Lubricate the wheel bearings and axles of the
Î
front wheels / cutter wheels via the grease nipples
with grease type 251H EP X .
Lubricate all blade shafts, tensioning pulleys and
Î
tensioning pulley holders via the grease nipples
using grease type 251H EP.
Note
Arrange for this work to be carried out by a
service centre.
Lubricate the steering with grease Type 251H EP
Î
via the grease nipples on the steering support.
Note
Arrange for this work to be carried out by a
service centre.
Have the dirt and grass residue beneath the V-belt
Î
cover of the cutter deck removed by a service
centre.
EN
23