Installing The Solid-State Drive - Dell OptiPlex 3090 Ultra Service Manual

Steps
1. Remove the (M2x3.5) screw that secures the solid-state drive module to the connector on the system board.
2. Lift and slide the solid-state drive module out from the M.2 slot.
3. Peel the solid-state drive thermal pad from the system board.

Installing the solid-state drive

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation
procedure.
Removing and installing components 105