KTM 450 XC ATV 2008 Setup Instructions page 5

SET‑UP
2 S ET ‑UP
Unpacking and assembling the vehicle
2.1
–
Remove box and foils.
–
Check the vehicle for transport damage.
–
Take the vehicle off the palette.
–
Unpack the by-pack kit and with the help of the list of contents, check that the
delivery is complete.
–
Remove the rear fender. (
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
200151-10
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ven-
tilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a doctor.
–
Fill the battery.
Info
Read the notes in the battery by-pack kit.
–
Recharge the battery. (
–
Install the battery. (
–
Print out the current PDI form from KTM DEALER.NET and carry out the post-delivery
inspection.
–
Insert the ignition key
Info
The key cover cap is in the tool set supplied.
Read the mounting instructions on the inside of the key cover cap.
100107-10
P. 4)
P. 5)
P. 6)
in the key cover cap .
1 2
3