Panasonic WV-CP450 Operating Instructions Manual page 32

1 (1 - - 16): 0 degrees
2 (1 - - 16): 22.5 degrees
16 (1 - - 16): 337.5 degrees
Note: After the sixteenth step, the adjustment
returns to the first step.
7. Move the cursor to FINE. The cursor starts blink-
ing.
8. Press or to match the vertical phase for
both video output signals as closely as possible.
(FINE adjustment can be made up to 22.5 degrees
by pressing or
Notes:
• When the "I" cursor reaches the "+" end, it
jumps back to "−". At the same time, COARSE
is incremented by one step to enable a contin-
uous adjustment. The reverse takes place
when the "I" cursor reaches the "−" end.
• When or
or longer, the "I" cursor moves faster.
.)
is kept pressed for a second
• To reset COARSE and FINE to the values pre-
set at the factory, press
ously. COARSE and FINE adjustments are
preset at the factory to zero-crossing of the
AC line phase.
• If the AC line contains noise (spike noise,
etc.), the stability of the vertical phase of the
camera video output signal may be disturbed.
6. White Balance Setting (WHITE BAL)
6-1. Auto-Tracing White Balance Mode (ATW)
You can select one of two modes for white balance
adjustment as follows:
• ATW (Auto Tracing White Balance)
In this mode, the colour temperature is monitored
continuously and thereby white balance is set auto-
matically. The colour temperature range for the
proper white balance is approximately 2 600 - 6
000K. Proper white balance may not be obtained
under the following conditions:
1. The colour temperature is out of the 2 600 -
6 000K range.
2. When the scene contains mostly high colour
temperature objects, such as a blue sky or
sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
-29-
or simultane-