Panasonic WV-CP450 Operating Instructions Manual page 26

4. Repeat step 1 to 3 to mask the desired area.To
cancel masking, move the cursor to that area and
press .
Turns to white
Blinking
5. After masking is completed, press
onds or longer. The ALC CONT menu appears.
6. If you want to change the video output level (pic-
ture contrast), move the "I" cursor for LEVEL and
adjust the level.
7. Move the cursor to RET and press
the CAM SET UP menu. (To return to the camera
picture, move the cursor to END and press the set
button.)
3. Shutter Speed Setting (SHUTTER)
Note: When ON is selected for SUPER-D on the ALC
CONT menu, this item is not available.
To select electronic shutter speed, select OFF for
SUPER-D in the menu.
You can select an electronic shutter speed of 1/50
(OFF), 1/120, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
or 1/10 000 seconds.
This function is effective to raise the sensitivity in low
light conditions when OFF is selected for ALC.
for 2 sec-
to return to
Move the cursor to the SHUTTER parameter and select
the electronic shutter speed.
The preset values for SHUTTER (electronic shutter
speed) change by pressing
OFF (1/50)
1/10000
-23-
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
LENS DRIVE DC
END SET UP ENABLE
or
1/120 1/250
1/4000 1/2000
as follows:
1/500
1/1000