Panasonic WV-CP450 Operating Instructions Manual page 30

Switcher, as closely as possible to the colour of
the original scene.
The SC FINE adjustment has a range of 90
degrees of colour shift.
Notes:
• When the "I" cursor reaches the "+" end, it
jumps back to "−" . At the same time, SC
COARSE is incremented by one step to
enable a continuous adjustment. The reverse
takes place when the "I" cursor reaches the
"−" end.
• When or is kept pressed for a second
or more, the "I" cursor moves quickly.
• For more accurate adjustment, supply both
the original camera video output signal and
the effect output video signal (program output
video signal) of the special effects generator
(SEG) to a vectorscope and compare the
chroma phase of both signals.
• To reset SC COARSE and SC FINE to the val-
ues preset at the factory, press
simultaneously. SC COARSE is reset to the
factory setting.
5-2. VS Gen-lock Mode (EXT(VS))
1. Move the cursor to the SYNC parameter and
select INT.
2. Connect the coaxial cable for the composite sync
or composite B/W video signal to the gen-lock
input connector.
3. Confirm that the parameter INT changed to EXT
(VS) on the menu.
Caution: The gen-lock input signal should meet
with EIA RS-170 specifications and should not
contain jitter, such as a VCR playback signal ,
as it could disturb synchronization.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
LENS DRIVE
or
END SET UP ENABLE
4. After confirming the cursor is on EXT (VS), press
. The phase adjustment menu appears on the
monitor.
-27-
** CAM SET UP **
OFF CAMERA ID
ALC ALC/ELC
--- SHUTTER
ON AGC
INT SYNC
ATW WHITE BAL
DC LENS DRIVE
END
OFF
ALC
---
ON
EXT(VS)
ATW
DC
SET UP ENABLE