General Diagram - Fagor DDS Hardware Manual

1.2 General diagram

See the schematic description of all the elements that make up the DDS servo drive system:
Mains connection.
Three phase 50/60Hz.TN mains
400-10% to 460+10% V AC
Mains filters:
MAINS FILTER A
Capacitor module CM 1.60.
It is connected in parallel to
the power bus (600 V DC).
Synchronous motors
FKM
F. H1/2
DDS servo drive system configurations.
Non-Regenerative
Power Supplies
Non-Regenerative Power Supplies
(they integrate the auxiliary power supply
PS-25B4
+ modular drives:
for axes: AXD, MMC
for spindle: SPD
Regenerative Power Supplies
(they integrate the Auxiliary Power Supply):
Regenerative Regulated
Power Supplies
RPS-XX
(they integrate the
+ Choke RPS-XX
Auxiliary Power Supply):
+ Modular Drives:
Compact Drives
(they integrate the Power Supply)
for axes: ACD, CMC
for spindle: SCD
FXM
PS-65A
+ modular drives:
for axes: AXD, MMC
for spindle: SPD
+ auxiliary power supply:
APS-24
XPS-XX
+ Choke XPS-XX
+ Modular Drives:
for axes: AXD, MMC
for spindle: SPD
for axes: AXD, MMC
for spindle: SPD
Resistor modules ER+TH-x/x or ER+TH-
18/x+FAN. They are connected to the
power supplies or to the compact drives.
Asynchronous motors
FM7/FM9
(discontinued)
  Description
1.
DDS
HARDWARE
SPM
Ref.1310
27