Table of Contents
Advertisement
6.5 Symptoms
If the product does not operate correctly, refer to the symptoms table below.
Symptoms
The product cannot go into
the charging station.
The product operates at the
incorrect time.
There is vibration in the prod-
uct.
The product operates, but the
blade disc does not rotate.
The product operates for
shorter periods than usual
between charges.
Operation and charging times
are shorter than usual.
The product is parked for
hours in the charging station.
1691 - 002 - 14.01.2022
Cause
The charging station is not put on a level
surface.
The charging station is put too far from
the work area.
The time and date of the product must be
set.
The start and stop time for operating are
incorrect.
The cutting system is not in balance be-
cause of damaged blades.
The cutting system is not in balance be-
cause of too many blades in the same
position.
Blades of different thickness are installed
on the product.
The product goes to the charging station. Usual operation for the product. The
Grass or other object causes a blockage
to the blade disc.
The battery is at the end of its life cycle.
The grass is high and thick.
The battery is at the end of its life cycle.
The product is parked because of the set
schedule setting, or because
further notice is selected.
The product does not operate if the bat-
tery temperature is too high or too low.
Action
Put the charging station on level surface.
Refer to
To examine where to put the
charging station on page 13 .
Make a new work area or move the
charging station.
Set the time and date. Refer to
date on page 24 .
Change the schedule settings. Refer to
Schedule on page 23 .
Examine the blades and screws and re-
place them if it is necessary. Refer to
placement of the blades and blade discs
on page 32 .
Make sure that only 1 blade is attached
to each screw.
Examine if the blades are of different
thickness and replace the blades if nec-
essary.
blade disc does not rotate when the
product goes to the charging station.
Remove and clean the blade disc. Refer
to
To clean the cutting deck and blade
discs on page 32 .
Replace the battery. Refer to
page 33 .
Increase the cutting height and then de-
crease it when the grass is shorter.
Replace the battery. Refer to
page 33 .
Change the schedule settings, or start
Park until
the product.
The product starts to operate again when
the temperature is between the set limits
and the schedule settings lets the prod-
uct operate. Make sure that the charging
station is put in an area with protection
from the sun.
Time &
Re-
Battery on
Battery on
Troubleshooting - 43
Advertisement
Table of Contents
