Table of Contents
Advertisement
and right cutting disc must switch positions to wear the
blades equally. The blades can be replaced when the
blade discs are installed on the product. You can also
remove the blade discs and then replace the blades.
5.6.1 To replace the blade discs
1.
Push the STOP button.
2.
Set the product to OFF.
3.
Put the cutting deck in service position. Refer to
put the cutting deck in service position on page 31 .
4.
Remove the coupling on the blade disc with the
Combi tool.
5.
Loosen the screw.
6.
Remove the blade disc.
7.
Clean the shaft and hub if it is dirty.
8.
Install the blade disc in opposite sequence.
5.6.2 To replace the blades on the blade
disc
1.
Remove the 5 screws.
1691 - 002 - 14.01.2022
To
2.
Remove the 5 blades.
3.
Attach 5 new blades and screws.
4.
Make sure that the blades can pivot freely.
5.7 Adjustment of the wheel brushes
The wheel brushes must be adjusted if they are worn.
Wheel brushes are available as accessory.
5.7.1 To adjust the wheel brushes
•
Loosen the screw with a T27 screwdriver to adjust
the wheel brushes. Make sure that the brushes
touches the bottom of the wheel threads.
5.8 Battery
CAUTION:
before you put the product into storage. If
the battery is not fully charged it can cause
damage to the battery.
If the operating time of the product is shorter than usual
between charges, this means that the battery is at the
end of its life cycle. Replace the battery to extend the
operating time.
0mm
Charge the battery fully
Maintenance - 33
Advertisement
Table of Contents
