Memory Mode; Changing The Temperature Scale; Temperature Taking Hints - Braun ThermoScan IRT6030CA Manual

6 Temperature displays.
The confirmation beep indicates that an accurate temperature
measurement has been taken. The result is shown on the display.
For the next measurement, press Eject button
7
to remove and discard used lens filter, and put on
a new, clean lens filter.
NOTE: Defaults to last age setting used if you do
not change.
The Braun ThermoScan ear thermometer turns
®
off automatically after 60 seconds of inactivity.
The thermometer can also be turned off by
pushing the Power button and holding it
for 3 seconds.
The display will briefly flash OFF and it will
go blank.

Temperature taking hints

Always replace disposable lens filters to maintain accuracy and hygiene. The right ear
measurement may differ from the measurement taken in the left ear. Therefore, always take the
temperature in the same ear. The ear must be free from obstructions or excess earwax build-up
to take an accurate reading.
External factors may influence ear temperatures, including when an individual has:
Factor
Poor probe placement
Used lens filter
Dirty lens
In the cases below, wait 20 minutes prior to taking a temperature.
Factor
Extreme hot and cold room temperature
Hearing aid
Lying on pillow
Use the untreated ear if ear drops or other ear medications have been placed
in the ear canal.
6
Yes affects
Yes affects

Memory mode

1
The last temperature taken is stored in its memory
and will be automatically displayed for 5 seconds
when it is turned on again.
Night light feature
The thermometer includes a convenient night light to illuminate
the display in a dim environment.
The light will turn on when you press any button. It will stay on
until the thermometer is inactive for up to 15 seconds even after
temperature is taken.

Changing the temperature scale

Your Braun ThermoScan is shipped with the Celsius (°C) temperature scale activated. If you wish
®
to switch to Fahrenheit (°F) and/or back from Fahrenheit to Celsius, proceed as follows:
1
Make sure the thermometer is turned off.
2 Press and hold down the Power button
the display will show this sequence: °C / SET / °F / SET ...
3 Release the Power button when the desired temperature scale is
shown. There will be a short beep to confirm the new setting, then the
thermometer is turned off automatically.
15 sec
. After about 3 seconds
7