Wiring - Furuno AIS Transponder FA-50 Operator's Manual

1. INSTALLATION
1.7

Wiring

Connect power source, LAN cable, VHF antenna and ground wire as shown below.
GPS Antenna
GPA-017/S
0.6 m
RG-10U/Y, 50 m
8D-FB-CV, 30 m/50 m: Option
RG-10U/Y, 20 m: Local supply
RS-422 RATING*2
*1: Supply from breaker on switchboard.
*2: If COM lines (connection for NavNet, sensor) are not used,
1-10
150M-W2VN
Either one
AIS TRANSPONDER
COM/POWER
NETWORK
12-24 VDC
2.0-1.0 A
PC, HUB,
NAVNET
POWER CABLE
(supplied)
12-24 VDC*1
RED BLACK
+ -
Switchboard breaker
tape them to prevent short circuit.
GPS/VHF Combined
Antenna GVA-100-T
Distributor
DB-1
VHF ANT
GPS ANT
LAN CABLE
P5E-4PTX-BL GROUND WIRE
(2 m or 10 m) IV-1.25sq
0.8 m
RG-10U/Y (8D-FB-CV,
option)
Attached to Distributor
(approx. 1m)
: Ground is not required.
GROUND
: Standard
: Option
: Local Supply