Furuno AIS Transponder FA-50 Operator's Manual page 16

1. INSTALLATION
How to attach the connector N-P-8DFB for cable 8D-FB-CV
Inner Sheath
Outer Sheath
Armor
50
Cover with heat-shrink tubing and heat.
30
Washer 1
Clamp
Gasket
Nut
(reddish
brown)
Trim shield here.
Trim aluminum
tape foil here.
Clamp Nut
1-6
Shield
30
10
Clamp
Aluminum Foil
Insulator
Washer 2
5
Spacer (white)
Pin
Shell
Solder through
the hole.
Remove outer sheath and armor by the dimensions
shown left.
Expose inner sheath and shield by the dimensions
shown left.
Cut off insulator and core by 10mm from its end.
Twist shield end.
Slip on clamp nut, washer 1, gasket and clamp as
shown left. If it is difficult to slip the clamp onto the
cable, use a file to enlarge the inner diameter of the
clamp.
Fold back shield over clamp and trim.
Cut aluminum foil at four places, 90° from one
another.
Fold back aluminum foil onto shield and trim.
Slit the washer 2, and trim insulator at the end of the
washer 2.
Expose the core by 5mm.
Slip the pin onto the conductor. Solder them together
through the hole on the pin.
Insert the pin into the spacer (white) and shell.
Screw the clamp nut into the shell.
(Tighten by turning the clamp nut. Do not tighten by
turning the shell.)