Io Data - Furuno FAR-2157-BB Installation Manual

5. IO DATA

Available input and output data are shown in the tables below and input and output sentences are
shown on the next page.
Note: This radar accepts position data fixed by WGS-84 geodetic datum only. Set the datum to
WGS-84 on the EPFS (GPS, etc.) connected to this radar. If other type of datum is input, the error
message "DATUM" appears and the AIS feature is inoperative.
Input
Data Specifications
Heading Synchro or step
signal
AD-10 format
IEC 61162-2
Speed signal IEC 61162-1
Navigator IEC 61162-1
data
External Heading, Bearing,
radar signal Trigger, Video
Alarm ACK Contact closure
input signal
Track Control RS-422
unit
Output
Data
Radar system RS-232C
data
ARPA data IEC 61162-1
Remote display Heading, Bearing, Tx
signal Trigger, Video
External LCD DVI
monitor signal
External CRT R, G, B, H, V
monitor signal
Alarm signal Contact closure
signal
GC-10 required
External AD-100
Position, course, speed, LORAN-
C TD, waypoint, route, time, wind
speed and direction, current data,
depth, water temperature, roll,
pitch, ROT
No GAIN, STC control
Specifications
RSD, OSD, TLL
TTM
Same as main monitor unit
Same as main monitor unit
Output to alarm system by using
photo-relay
Contents
Contents
Remarks
Switching between AD-10
and IEC 61162 is done
from menu.
Operate as remote display
Input signal from alarm
system
Option
Remarks
For PC plotter
For ECDIS
2 ports
2 systems max.
Option
4 outputs, output
content selected from
menu.
5-1