Furuno FAR-2157-BB Installation Manual page 68

it
Type
OP03-28900 000-082-658
OP03-28910 000-082-689
OP03-28920 000-082-660
Note: When two memory card interface units are connected via a network, change ID code for the
second unit.
1. Remove the cover and set the IP0 bit of the DIP switch S1 on the CARDCPU board (03P9333)
to ON.
2. Set INIT bit of S1 to ON and turn on the radar. Wait until CR2 starts blinking. DO NOT turn off
the power until CR2 starts blinking.
3. Turn off the power and set INIT bit to OFF.
CARDCPU board 03P9333
Memory card interface unit, showing location of DIP switch S1
4-12
Armored LAN cable kit
Code No.
Cable FR-FTPC-CY (10 m), Modular connector (2 pcs.)
Cable FR-FTPC-CY (20 m), Modular connector. (2 pcs.)
Cable FR-FTPC-CY (30 m), Modular connector (2 pcs.)
J314
S1
CR2
Contents
ON OFF
IP0
IP1
IP2
INIT
(Default: all OFF)