R-Calib Display - Furuno Satellite Compass SC-50/110 Service Manual

4) R-CALIB display

R-CALIB (Rate sensor Calibration) is used to enter the calibration value of the rate sensor at
factory. It is not necessary to change this value when the rate sensor is replaced with new one.
However, the value on top of the original sensor is written on top of the replacement sensor
for future service.
S1 (Pitch*)
*: Default
R-CALIB
S1 : +0.0%
S2 : +0.0%
S3 : +0.0%
S2 (Roll*)
Fig. 7 Rate sensors in Processor Unit
S3 (Yaw*)
4
Fig.6