Related Manuals for CDA EIN60
Summary of Contents for CDA EIN60
- Page 1 EIN60 Extractors Installation, use and maintenance www.cda.eu Cod:0103086436-00.03...
- Page 2 Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model...
- Page 3 Declarations of Conformity: This appliance has been manufactured to comply with all EU & UK statutory requirements and complies with all applicable legislation and the following European Directives: • The Low Voltage Directive 2014/35/EU • Electromagnetic Compatibility Directive 2014/30/EU The product has been marked with the UKCA and CE symbols. This appliance is marked according to the European directive 2004/104/EC on Waste Electrical and Electronic equipment (WEEE).
- Page 4 • Do not tile the extractor in. It should be removable for service or maintenance. • Do not use silicone sealant to secure the hood to the wall. • You must be able to isolate the extractor from the mains electrical supply after installation.
-
Page 5: Using Your Extractor
Using your extractor For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking. Fig. 1 Control Panel A – Light switch B –... -
Page 6: Care And Maintenance
Care and maintenance IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEAN- ING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. Cleaning You should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. - Page 7 Acrylic grease filter: 1. Remove the cover panel by pushing the fixing clips up and then lifting the panel forwards. 2. Remove the filter retaining wires from the cover panel. 3. Remove the grease filter and wash by hand in a lukewarm solution of water and mild detergent.
-
Page 8: Changing The Light
Changing the (circular) charcoal filter (re-circulating only): To ensure best performance of your extractor, you should replace the charcoal filters every four to six months, depending on use. Please note the charcoal filter cannot be washed. To attach a new charcoal filter, follow the steps below: 1. -
Page 9: Mains Electricity Connection
Bulbs of a lower power rating may be ad- equate for use, generally last longer and use less energy. • Spare bulbs are available from CDA Customer Care or from your local DIY shop. Mains electricity connection... - Page 10 As the colours of the wires in the mains lead for the appliance may not correspond with the coloured markings identifying the terminals connecting to the fused spur, proceed as follows: • The wire which is coloured blue must be connected to the terminal marked N (Neutral), or coloured black.
-
Page 11: Electrical Information
2. Check that the fuse in the spur has not blown. Contact CDA Customer Care A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu W : www.cda.eu... -
Page 12: Installation Preparation
Installation - preparation When the extractor is to be installed above an electric hob, the minimum distance between the hob and extractor must exceed 600mm for ceramic and solid plate hobs and 550mm for induction Hobs. When the extractor is to be installed above a gas hob, the minimum distance between the hob and extractor must exceed 650mm. -
Page 13: Installation - Mounting
The metal casing of this appliance has been coated with a preservative to protect it during transport and storage. This should be removed during installation by using a non-abrasive stainless steel cleaner. Always follow the instructions given with the cleaner being used. - Page 14 Fig4 Fig. 5 Ducting The ducting used should be rigid circular pipe and must be manufactured from fire retardant material, produced to BS 476 or DIN 4102-B1. Wherever possible utilise rigid circular pipe which has a smooth interior, rather than the expanding concertina type ducting. The lengths of ducting with minimal effect on performance are as follows: •...
- Page 15 Sound power level 70 (D) 46.2 (F ) Hood 14 (D) 14 (D) Hood E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the right to change specifications without prior notice.
- Page 16 01949 862 012 or email customer.care@cda.eu For more information please contact: The Sales Department on 01949 862 010 or email sales@cda.eu Customer Care Department. The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY 01949 862 012 01949 862 003 customer.care@cda.eu www.cda.eu...