IBM 9306 Hardware Maintenance Manual page 99

2. Place the tray on a stable flat surface; then, carefully cut the cable straps on
the cable-management arm and slide rail to release the bundled cables. Move
the power cords out of the way, but keep them nearby for later in the
installation procedure.
Attention: The video cable is already connected to the flat panel monitor. Be
careful as you install the tray in the rack cabinet that you do not pinch or cut
the video cable.
3. Fully extend the tray; then, carefully lift the rear of the flat panel monitor and
raise the monitor to the full upright position.
4. To remove the cable cover from the tray, remove the cable-cover screw; then,
slide the cover toward the front of the tray until the tab on the tray can fit
through the slot on the cover. Lift the cable cover from the tray and set it aside
Cables
Cable tie
1U Flat Panel Monitor Console Kit
89