IBM 9306 Hardware Maintenance Manual page 24

Note: You do not need to remove the rear filler panels unless you are attaching the
Removing and installing side panels: Use the following procedure to remove
the NetBAY42 side panels:
Figure 10. Removing the NetBAY42 side panels
1. From the inside rear of the rack cabinet, slide the side panel locking bar into the
2. Tilt the bottom of the side panel slightly toward you; then, lift the side panel
3. Repeat this procedure to remove both side panels.
Reverse this procedure to install the side panels. Slide both locking bars into the
locked position to secure the side panel to the rack cabinet.
14
Hardware Maintenance Manual: IBM PC Server/Enterprise Racks Types 9306, 9308
rack cabinets to form a suite of rack cabinets.
Side panel
Rear locking bar
unlocked position; then, slide the front side panel locking bar into the unlocked
position.
away from the tabs on the top of the rack cabinet.
Front
locking
bar