Advertisement
Stage One — Install the Screen and Projector
Stage 1
This stage involves installing the three pieces of hardware shown below.
PCM 240 Projector Ceiling Mount
Pipe
Adapter
Set Screws (2)
T-bar
Securing
Screws (4)
Where it goes:
Attaches to structural ceiling, rests on
suspended ceiling.
What it does:
Holds PMP, Pole Mount Kit
(see Stage 4), and projector.
UPB 25 Universal Projector Bracket (shown separated into the two sections)
Adjuster Plate
(Top Section)
Vertical Angle
Adjustment
Screws (4)
Pivot
Point
Screw
Where it goes:
Adjuster plate screws onto base of PMP, and projector bracket attaches to projector.
What it does:
Attaches projector to PMP. Allows projector orientation to be adjusted in three planes.
2-2
PoleVault Systems Installation • Installation — Stage 1
1-gang and 2-gang Accessory
Mounting Points (e.g. power sockets)
Pipe
Adapter
Pipe Adapter Plate
Lock Nuts (4)
Set Screws (2)
Horizontal Angle
Adjustment Screws (4)
Pivot Point screws (4)
Security Flange
(on rear)
PMP Projector Mounting Pole
Threaded at both
ends
Where it goes:
Screws up into PCM 240.
What it does:
Holds Pole Mount Kit and
projector.
Projector Bracket
(Bottom Section)
Adjuster Plate
Locking Screws (4)
360° Movement
Cable
Access
Cutout
(install this
end uppermost)
Projector Securing
Screw
Threaded
Barrels (4)
Arm Adjustment
Screws (4)
Security Flange
(on rear)
Advertisement
