Extron electronics PMK 155 Installation Manual

PMK 155 • Installation Guide
The Extron PMK 155 Pole Mount Kit is a simple solution for mounting Extron devices and their external power supplies to a
projector pole. The PMK can be installed on a 1.5-inch pipe within a 4-inch space between the projector and the ceiling.
Any of the following devices can be mounted, along with their power
supply:
•
One 3-inch deep half-rack device
•
One 6-inch deep half-rack device
•
Two 3-inch deep quarter rack devices
•
Four 4.5-inch deep eighth rack devices
•
One MPA 401
ATTENTION:
•
The maximum load for the PMK 155 is 5 lbs (2.25 kg).
•
La charge maximum pour le PMK 155 est 2,25 kg (5 lbs).
•
Only for use with Extron UL listed products.
•
À utiliser uniquement avec les produits d'Extron, certifiés UL.
Installation
ATTENTION:
•
All electrical installation should be performed by qualified personnel in accordance with local and national building
codes, fire and safety codes, and local and national electrical codes.
•
Toute installation électrique devrait être effectuée par un personnel qualifié, conformément aux codes du bâtiment, aux
codes incendie et sécurité, et aux codes électriques locaux et nationaux.
To install the PMK 155 (with a device) on a projector pole:
1. Place the plate on the base of the device and align holes in the plate
with the mounting holes in the device.
2.
Secure the device to the plate with 4-40 screws.
ATTENTION:
•
Use only supplied screws to avoid damaging the
device.
•
Utilisez seulement les vis fournies pour ne pas
endommager l'appareil.
3. Attach the power supply to the underside of the mounting plate by
passing the supplied tie wraps under the power supply, through the
raised slots in the plate, and back over the power supply.
Ensure the tie wraps sit in the grooves on the power supply. Tighten
the ties until snug.
(2) Hex Bolts
(2) Washers
(6) #4-40 Screws
(4) Tie Wraps
Use 2 mounting holes on
opposite corners.
Power Supply
Mounting Plate
(2) 4-40 x 3/16"
Screws
PMK 155
1