Filling The Container - Stihl SR 200 Instruction Manual

13 Filling the Container

12.3.2 Discharge rate (l/min) without pressure
pump, with ULV nozzle
Spray tube angle
Knob set‐ - 30° 0°
ting
0.5 0.05 0.04 0.03
0.65 0.08 0.07 0.05
0.8 0.12 0.09 0.08
12.3.3 Discharge rate (l/min) with pressure
pump (special accessory)
Spray tube angle
Knob set‐ - 30° 0°
ting
1.0 0.64
1.6 1.7
2.0 2.59
12.3.4 Discharge rate (l/min) with pressure
pump (special accessory) and ULV
nozzle
Spray tube angle
Knob set‐ - 30° 0°
ting
0.5 0.15
0.65 0.2
0.8 0.37
12.4 Checking Flow Rate
► Place the unit on the ground.
► Fill the container with water up to 10 liter mark.
Machines without pressure pump
► Set the "standard" metering knob to 6.
► Start the machine.
► Hold the spray tube horizontally, run the
engine at full throttle, spray the contents of the
container down to the 5 liter mark and note the
time taken.
The time required to spray 5 liters fluid should be
between 110 and 150 seconds.
Machines with pressure pump (special acces‐
sory)
► Fit metering knob 2.0 in the nozzle.
► Start the machine.
► Hold the spray tube horizontally, run the
engine at full throttle, spray the contents of the
container down to the 5 liter mark and note the
time taken.
The time required to spray 5 liters fluid should be
between 100 and 130 seconds.
0458-457-0121-C
+ 30
°
+ 30
°
+ 30
°
In case of deviations:
► Check the container, hose system, metering
knob and optional pressure pump for contami‐
nation and clean if necessary.
► Check blower air intake and clean if neces‐
sary.
► Check engine setting and correct if necessary.
If there is no improvement, contact your dealer
for assistance.
13 Filling the Container
► Turn the cap counterclockwise until it can be
removed from the container opening.
1
► The gasket (1) in the cap must be in good con‐
dition and clean.
► Stand the machine on a level surface.
► Close valve lever (1) for solution feed.
► Pour thoroughly mixed spray solution into the
container through the strainer.
English
1
17