(10) EDIT MULTIPLE MOTION AREA
Enter a desired channel, and press SELECT to edit a motion area. Please make sure that
MOTION is set as "Enable" before entering the motion detection area.
?
To test a motion area: Grids will turn into light red from light green when a motion is detected.
?
To clean up the entire area: Press PLAY to clean up the entire motion area.
?
To get a motion area setting hint: Press DISPLAY to get a hint window (shows below) in motion
edit mode.
MENU
- EXIT
COPY
- SELECT AREA
ENTER
- CHANGE DIR
SEARCH
- ON AREA
PAUSE
- OFF AREA
In the motion edit mode:
The default motion area of each camera is
entire screen which displays in light green.
Press COPY to start to set an area.
Then press SEARCH to end and enable the
area, or press PAUSE to end and disable
the area.
Dial JOG to select a horizontal
a vertical
to switch a horizontal
area.
Press MENU to quit the motion area edit.
41
or
area, and press ENTER
or vertical