EverFocus 410M Instruction Manual page 28

Installing the Camera(s) and Monitor
The DVR is typically connected to one camera installed inside the car. Other camera(s) can also be installed in different
locations (for example, use the waterproof camera to the outside of vehicle). For installation procedure, refer to the guide
that came with the camera(s) you purchased.
The Monitor power supply connects from the Automotive adapter (c igarette plug)
Monitor and cameras must be purchased separately.
Connect the Camera(s)
Connect the power connector from the camera(s) harness into the CAMERA POWER OUT jack on the back panel
of the DVR.
Connect the primary camera(s) video connector to the CAMERA INPUT and the audio connector to the AUDIO
INPUT in the back panel.
Adjust the camera(s). After the camera is installed, connect a monitor directly to the camera and observe the image.
Make any adjustment if necessary.
LCD Monitor
26
LCD Monitor