Epson TM-T60/T60P Operator's Manual page 51

Sets the print starting position to the specified number of
dots (1/180 inch units) from the beginning of the line.
- Divide the number of dots by 256. The integer answer is
n2
position becomes n1+n2X256 from the beginning of the
line.
- Any specification that exceeds the end of the line is ignored.
Not defined.
ESC ¥
ESC ¥ n1 n2
Set relative position
< 1B >
Moves the print starting position to the specified number of
dots (1/180 inch units) from the current position.
- A positive number specifies movement to the right, and a
negative number specifies movement to the left.
- Negative numbers are specified using the supplement of N;
- N
- Divide the number of dots by 256. The integer answer is
n2
- Any specification exceeding the printable area will be ignored.
Not defined.
ESC $
GS k n [d]k NUL
Print bar code
< 1D >
Selects a bar code system and prints the bar code.
- Sets the print starting position to the beginning of the line.
- n selects the bar code system from the following table.
and the remainder is n1. Therefore, the print starting
< 5C > < n1 >< n2 >
H H
= 65536 - N
and the remainder is n1.
< 6B > < n >[< d >]k < 00 >
H H
- 4 4 -
H