Lighting Instructions - Empire Comfort Systems DV-55IP Installation Instructions And Owner's Manual

Fan type direct vent wall furnace
Table of Contents

Advertisement

FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
A. This appliance is equipped with an ignition device which
automatically lights the pilot.
Do not try to light the pilot by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
Do not use any phone in your building.
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
1. STOP! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition
device which automatically lights the pilot. Do not try
to light the pilot by hand.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance
if service is to be performed .
3. Remove control access panel (lower front
panel).
Page 12

LIGHTING INSTRUCTIONS

causing property damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or turn
by hand, don't try to repair it; call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
5. Remove control access panel (lower front panel).
6. Turn gas control knob clockwise
to "OFF."
7. Wait ten (10) minutes
Then smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the safety information above.
If you don't smell gas, go to the next step.
8. Tu r n g a s c o n t ro l k n o b c o u n t e rc l o c k w i s e
to "ON".
9. Replace control access panel (lower front
panel).
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
"TO TURN OFF GAS TO APPLIANCE" and call your
service technician or gas supplier.
4. Turn gas control knob clockwise
to "OFF." Do not force.
5. Replace control
panel).
to clear out any gas.
access panel
(lower front
12432-9-0107

Advertisement

Table of Contents
loading

Table of Contents