Table of Contents
Advertisement
Quick Links
This appliance may be installed in an after-
market permanently located, manufactured
(mobile) home, where not prohibited by state
or local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appli-
ance is not convertible for use with other
gases, unless a certified kit is used.
WARNING: If not installed, operated and
maintained in accordance with the manu-
facturer's instructions, this product could
expose you to substances in fuel or from fuel
combustion which can cause death or seri-
ous illness.
R-3122
INSTALLATION INSTRUCTIONS
OWNER'S MANUAL
AND
FAN TYPE
DIRECT VENT
WALL FURNACE
MODEL
DVC-35-1SPP
DVC-35-1IP
EFFECTIVE DATE
AUGUST, 2000
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or loss of life.
— Do not store or use gasoline or other
flammable vapors and liquids in the vi-
cinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do
not use any phone in your building.
•
Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
•
If you cannot reach your gas supplier,
call the fire department.
— Installation and service must be per-
formed by a qualified installer, service
agency or the gas supplier.
Page 1
Advertisement
Table of Contents
Related Manuals for Empire Comfort Systems DVC-35SPP
Summary of Contents for Empire Comfort Systems DVC-35SPP
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS OWNER'S MANUAL FAN TYPE DIRECT VENT WALL FURNACE MODEL DVC-35-1SPP DVC-35-1IP EFFECTIVE DATE AUGUST, 2000 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. —... - Page 2 Specifications Model DVC-35SPP DVC-35IP General Information This furnace is design certified in accordance with American Input BTU/HR 35,000 (10.3)
- Page 3 SAFETY INFORMATION FOR USERS OF LP-GAS Propane (LP-Gas) is a flammable gas which can cause fires by point with the members of your household. Someday when there may not be a minute to lose, everyone's safety will and explosions. In its natural state, propane is odorless and colorless.
- Page 4 Qualified Installing Agency The vent terminal of this direct vent appliance shall be located at Installation and replacement of gas piping, gas utilization equip- least 9" (229mm) from any opening through which flue gases ment or accessories and repair and servicing of equipment shall could enter a building.
- Page 5 6. Position and attach inner boot to inner shield with (4) #8 x 1/4" Locating Gas Supply (6mm) provided screws. The gas line can enter the furnace either through the floor or 7. Place the register over the 6 3/4" (171mm) square opening outside wall.
- Page 6 3. Attach 6" (152mm) diameter air inlet tube onto the collar of air Mark the 6" (152mm) diameter air inlet tube 1/2" (13mm) drop assembly. Attach caulked, outside mounting plate into the beyond the outside wall. Remove 6" (152mm) diameter air inlet 6"...
- Page 7 Gas Supply Attention! If one of the above procedures results in pressures in Check all local codes for requirements, especially for the size and excess of 1/2 psig (14" w.c.) (3.5 kPa) on the appliance gas valve, type of gas supply line required. On Natural gas lines less than 75' it will result in a hazardous condition.
- Page 8 To clean burner port disconnect the gas supply to the valve, and remove the screws fastening the burner door. After removing the THERMOCOUPLE burner door from the burner box, remove each main burner. Pilot mounting bracket will need to be unscrewed and moved out of the way to remove all burners.
- Page 9 FAN SWITCH LIMIT SWITCH BURNER BOX GAS VALVE PIEZO IGNITOR JUNCTION BOX- TRANSFORMER Figure 12 Figure 11 R-3122 Page 9...
- Page 10 O pressure on Natural gas and 10" H 4. Type of gas being used and that shown on the rating label. pressure on LP gas. The Service Department at Empire Comfort Systems, Inc. may be contacted to assist in servicing furnace. Pilot Flame Adjustment...
-
Page 11: For Your Safety Read Before Lighting
STANDING PILOT MODEL FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by •... -
Page 12: For Your Safety Read Before Operating
INTERMITTENT PILOT (IP) MODEL FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance is equipped with an ignition device •... -
Page 13: Sequence Of Operation
SEQUENCE OF OPERATION Apply 24 VAC to Appliance START Thermostat Calls for Heat 5 Minute Retry Delay Flame Signal • Pilot Valve Ignition OFF Detected • Wait for Flame Signal to Disappear System Check Internal Check Trial for • Pilot Valve Opens Ignition •... - Page 14 IP SYSTEM TROUBLESHOOTING SEQUENCE START End View INSET A SmartValve™ System Troubleshooting Sequence of Control 24Volt • Turn OFF Gas Supply Note: Before Troubleshooting, Become Familiar Harness Thermostat • Disconnect System Control with the Sequence of Operation Connector Harness • Set Thermostat to Call for Heat Volts Output...
- Page 15 Do not order bolts, screws, washers or nuts. They are standard hardware items and can be purchased at any local hardware store. Shipments contingent upon strikes, fires and all causes beyond our control. Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529...
- Page 16 Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529 Page 16 R-3122...