Emerson MS7625 Owner's Manual page 13

MAKING A TAPE RECORDING
You can record directly from the Radio or CD player to the cassette recorder.
1. Press the POWER button to switch the system 'On'. The Power 'On' Indicator
comes on.
2. Select the source you wish to record, Radio or CD, and follow the instructions
for that function.
3. Press the STOP/EJECT
quality blank cassette into the slots on the door with the exposed tape facing
down and the full reel on the left side. Close the cassette door.
4. When you are ready to begin recording, press the RECORD
key will also engage and recording begins.
• This system features an Automatic Level Control (ALC) recording volume
circuit which controls the recording volume to prevent distortion. The main
volume control has no effect on the recording. You may raise or lower the
VOLUME control during the recording or shut it off completely, if desired.
• You can use the PAUSE
recording unwanted material, such as radio commercials.
5. When you are finished recording, press the STOP/EJECT
the tape and, again, to open the cassette door.
IMPORTANT NOTES ABOUT RECORDING
• Do not force the RECORD
may have a missing erase prevention tab.
Refer to the section on "ABOUT CASSETTE TAPES" for more information.
• When you record over previously recorded material, the original material is erased
as the new material is recorded.
• Use good quality, brand-name blank tapes for recording. However, do not use
"Metal" or "CrO2 (Chrome)" tape formulations in this recorder.
• When recording from AM radio, you may experience an oscillation or 'Beating'
noise. If this occurs, set the FM MODE/BEAT CUT switch on the back panel to
the opposite position.
MS7625_ib.p65
button to open the cassette door. Insert a good
key to stop the recording temporarily to avoid
button. If it does not engage easily, your cassette
12
12
key. The PLAY Y
key once to stop
02/19/2001, AM 10:59