Bluetooth Operation - Dual XML8150 Installation & Owner's Manual

Preparation
Pairing a New Device
Pairing Additional Devices
Most Bluetooth devices support the auto-connect feature, and will connect automatically
if the device is in range when the XML8150 is powered-on. If your device was previously
paired but does not connect, use these instructions below.
• If your most recently connected Bluetooth device becomes disconnected or does not
reconnect, press
• To connect a previously paired device that was not recently connected:
1) If applicable, press and hold
2) From Bluetooth mode, press SELECT. "PAIRED DEVICES" will appear on the LCD.
3) Turn the volume knob to cycle through the list of devices 1 through 10.
4) Press SELECT or
Note: If the AUTO-CON setup menu setting is set to OFF, you must press
you device after pairing, and each time the XML8150 is powered-on.
Press and hold
paired and appear in the PAIRED DEVICES menu, but not be connected.
Bluetooth
Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your
device before you begin the pairing process.
The XML8150 broadcasts the pairing signal constantly when
no devices are currently connected. Complete the pairing
sequence from your Bluetooth device. Refer to the owner's
manual for your device for more details.
The device name is "XML8150"
The Bluetooth passcode "1234"
Note: The XML8150 can be in any mode of operation when
pairing is performed.
If a device is currently connected, press and hold
disconnect the current device before a new device can be
paired. Then begin the pairing sequence from the new
Bluetooth device.
from Bluetooth mode to reconnect your mobile device.
to connect to the desired device. It must be in range to connect.
for 3 seconds to disconnect a connected device. The device will remain
XML8150 OPERATION
Operation
®
Connecting a Paired Device
to disconnect any connected mobile devices.
Pairing a Device
Disconnecting a Device
to
to connect
23