Page 1
XDMA7650 INSTALLATION/OWNER'S MANUAL AM/FM/CD/MP3/WMA Receiver with USB, ® Control for iPod and 2-Step Motorized Face...
Page 2
XDMA7650 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
PAC SWI-PS required Subwoofer Preamp Output FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XDMA7650 uses one 10 amp ATM fuse located beside the wiring connector.
XDMA7650 OPERATION General Operation Power On/Off Source Auxiliary Input Steering Wheel Interface Input Volume Display Reset Set the Clock 12/24-hour Clock Press or any other button (except EJECT or OPEN) to turn the unit on. Press and hold off. Press SOURCE to select between AM/FM, CD player, USB, operation of iPod and auxiliary input. Modes of operation are shown in the display.
Page 7
DIMMER LOW DEMO OFF Demonstration Mode DEMO ON XDMA7650 OPERATION General Operation - Setup Menu Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu. Press AUDIO/MENU momentarily to select between the menu functions and rotate the volume knob left/right to adjust or activate the desired function.
Page 8
XDMA7650 OPERATION General Operation Audio Press AUDIO momentarily to select between Bass, Treble, Balance, Fader, EQ, Subwoofer and Source Volume Level. BASS TREBLE BALANCE FADER SUBWOOFER* SOURCE LEVEL Bass Press AUDIO until BASS appears then rotate volume knob left/right to adjust ( -6 minimum / +6 maximum).
Page 9
Seek Tuning Manual Tuning Band Storing and Recalling Station Presets XDMA7650 OPERATION AM/FM Tuner Operation Press TUNE or TUNE to seek to the next strong station. Press TUNE or TUNE radio frequency up or down one step at a time. Press and hold to advance quickly. Press BAND to select between FM1, FM2, FM3, AM1 and AM2 bands.
XDMA7650 OPERATION CD Player Operation Insert CD Eject CD Track Select Fast Forward and Reverse Pause Intro Repeat Random CD-R/CD-RW Compatibility Press EJECT to access the CD slot. With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Press EJECT to eject the CD. The unit will change to previous mode of operation.
Page 11
XDMA7650 OPERATION CD Player Operation - MP3/WMA Files Playing an MP3/WMA Disc When an MP3/WMA encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. Displaying Information Press DISPLAY to select between title (default), artist, file name, folder name, track number, and clock/elapsed time.
Page 12
XDMA7650 OPERATION CD Player Operation - MP3/WMA Files Folder/File Search Mode Step 1 Step 2 Step 3 Step 4 MP3/WMA CD mode features a file and folder search mode. This search allows navigating through folders to find a specific MP3 or WMA file for playback. Press SELECT. "MP3 CD SEARCH" will appear, then a list of the files in the currently selected directory will be accessible.
Page 13
• FOLDER - Plays first 10 seconds of each track in folder. Note: Folder repeat, random and intro options only function on MP3/WMA discs recorded with more than one folder. XDMA7650 OPERATION to select the previous folder. to select the next folder.
Page 14
XDMA7650 OPERATION CD Player Operation - MP3/WMA Files Media Compatibility Playback Order Compatible Recording Formats The following types of discs/files are compatible: • CD-ROM (ISO), CD-R, CD-RW • CD-DA • MP3 data • WMA data The following types of discs/files are not compatible: • WMA files that are protected by DRM (Digital Rights Management).
Page 15
Information Sampling Frequency Rates Transfer Bit rates MP3 Tag Display Recommended Settings XDMA7650 OPERATION An internal buffer provides ESP (Electronic Skip Protection) to virtually eliminate skipping. When playing a disc recorded with regular audio files (CD-DA or .WAV) and MP3/WMA files, the unit will play the MP3/WMA files only.
Page 16
Step 2 Step 3 Play MP3/WMA files from most mass storage devices by connecting them to the XDMA7650's USB port. When a USB device is first connected, “READING” will appear in the display and playback will begin momentarily. Depending on the number of files and folders, it may take several seconds for the device to begin playing.
Page 17
Folder Access Repeat Random Intro XDMA7650 OPERATION When a file is accessed, the clock and elapsed time will be displayed. Press DISPLAY momentarily to select beween artist, song title, file name, folder name, track number and clock/elapsed time. "NO TITLE" will be displayed if no song title information is available.
Page 18
XDMA7650 OPERATION USB Operation - MP3/WMA Files Character Support Maximum character display information • Track name – 32 character maximum • Directory name – 32 character maximum • *Song title – 30 character maximum • *Artist name – 30 character maximum *Song title and artist name will only be displayed if included with the MP3/WMA file.
Page 19
Additional MP3/WMA Information Sampling Frequency Rates Transfer Bit rates MP3 Tag Display XDMA7650 OPERATION USB Operation - MP3/WMA Files Only MP3 files with filename extension (.mp3) can be played. Only WMA files with filename extension (.wma) can be played. Do not attempt to play non-MP3/WMA files with the MP3/WMA extension. 8kHz ~ 48kHz...
Menu Podcast Menu The XDMA7650 features a direct USB control system for iPod. To play music from an iPod device, connect the USB cable (included with your iPod device) to the XDMA7650's USB port. Once connected, READING will appear in the display.
Page 21
• • • • • • XDMA7650 OPERATION Operation of iPod to skip to the beginning of next song. Press to return to the beginning of current song. Pressing again skips to the beginning of previous song. / II to temporarily stop playback.
INVALID appears on display Unit will not accept a disc NO SUPPORT appears An invalid ID3 tag version is present on display XDMA7650 OPERATION Cause voltage Red wire not connected or incorrect voltage Black wire not connected Fuse blown Speaker wires not connected Yellow or red wire touching chassis...
XDMA7650 OPERATION Specifications CD Player FM Tuner AM Tuner General Power Output: 18 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 80dBA (reference: 1 watt into 4 ohms) Frequency response: 10Hz-20kHz Channel separation @ 1kHz: D/A converter: 1 Bit...
Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. XDMA7650 OPERATION FCC Compliance...