Wiring (Miscellaneous Cover Components Of The Sewing Machine) - JUKI PS-800-12080 Instruction Manual

❸ ❸

3. Wiring (miscellaneous cover components of the sewing machine)

⑨⑬ ⑨⑬
❻ ❻
⑬ ⑬
7) Pressing the retaining spring of the AT thread
tension controller asm. against the end surface
of the tension controller mounting hole, secure
it with screw ❸ at a position where the stroke of
the thread take-up spring becomes 4 to 5 mm.
If you cannot press the retaining
spring of the thread tension controller
asm. against the end surface of the
mounting hole, loosen bracket screw
❻ of the AT thread tension controller.
After pressing the retaining spring
against the end surface of the mount-
ing hole, temporarily tighten bracket
screw ❻ .
1) Wire AT solenoid cable ② along the route indi-
cated with the red dotted line as shown in the
figure on the left.
During this procedure, loosen the screw and
tighten fixing base ⑨ . Then, secure the cable
with cable clip band ⑬ .
2) Wire AT solenoid cable ② along the route indi-
cated with the red dotted line as shown in the
figure on the left.
Insert the termina-side cable through the inter-
mediate-part opening in the cover and pass it
through the sewing machine.
During this procedure, loosen the screw and
tighten fixing base ⑨ . Then, secure the cable
with cable clip band ⑬ .
3) Wire AT solenoid cable ② along the route indi-
cated with the red dotted line as shown in the
figure on the left.
Draw out the cable from the rear opening in
the cover and secure it together with other
cables with cable clip band ⑬ .
– 5 –