Denon DVD-1000 Operating Instructions Manual page 11

(3) Connecting to a AV amplifier with a built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player's digital
audio output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence
of a movie theater or concert hall.
DVD-1000
Front speaker (left)
Surround speaker (left)
NOTES:
• Set the " AUDIO OUTPUT "
" " "
• Set the TV TYPE in VIDEO SETUP
(See page 37.)
• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using a
decoder, etc., that is not DTS-compatible.
2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)
Dust cap
Remove the dust cap, line up the cable in the proper directly, then
insert it securely as far as it goes.
TV
DIGITAL OUT AUDIO VIDEO S-VIDEO
OUT OUT OUT
(PCM/BITSTREAM)
L
COAXIAL OPTICAL
R
Optical fiber cable
75 /ohms pin-plug
(commercially available)
cable (commercially
available)
Digital audio input
connector (COAXIAL)
AV amplifier with a built-in decoder
(AV control center)
in " AUDIO SETUP " in " SETUP "
" " "
in SETUP comply with your TV's video format. When the TV is NTSC formated, set to NTSC.
Line up in proper direction
VIDEO IN
COMPONENT
VIDEO OUT
C C Y
R B
Center speaker
Front speaker (right)
Subwoofer
Digital audio input
connector (OPTICAL)
Surround speaker (right)
setting to " DIG./NORMAL " . (See page 38.)
NOTE:
• Store the dust cap in a safe place, and be careful not to
lose it.
When not using the terminal, attach the cap to protect
the terminal from dust.
ENGLISH
To power outlet
11