Table of Contents
Advertisement
STOP! Closely inspect to make sure no components are missing or damaged. See the
Inspect Upon
"Assembly and Initial Set-Up" section for instructions on whom to contact to report missing or
Delivery
damaged parts.
STOP! Engine is shipped without oil. DO NOT start pressure washer without adding oil to
Fill with
engine. Please refer to Engine Manual shipped with unit for acceptable grade motor oils.
Engine Oil
Refer to the Prepare Engine instructions in Step 3. Initial Pump & Engine Preparation of the
Assembly and Initial Set-up section for additional oil quantity needed due to oil drain hose.
Pump is shipped with oil. Check pump oil level before starting. Remove shipping tape and
Check Pump
black vent plug (if present) from oil fill cap.
Oil
Make sure your supply water flow rate is 20% higher than the pressure washer's flow rate
Water Flow
(see "Specifications" section for detail), and that your water is clean and particle free.
Requirements
Storage Do not allow water to freeze in the pump, hose, coil, or spray gun(s).
Chemical
Use only NorthStar brand or equivalent washer chemicals designed for pressure washer
Spraying
use.
Maintenance
Engine:
Schedule
Pump:
Burner fuel filter
/water separator:
Coil:
Electrodes:
Hazard Signal Word Definitions
Equipment Protection Quick Facts
See Engine Owner's manual.
•
•
Change oil after first 40 hours, then every 3 months or 500
hours.
•
Drain water as needed.
•
Change filter after every 500 hours of use
•
Descale coil annually or more frequently as conditions /
performance require.
•
Inspect coil for soot build-up annually and desoot if needed.
•
Inspect electrodes annually and clean/adjust as needed.
2
Advertisement
Table of Contents
