Table of Contents
Advertisement
d 、 Select "Switch-off delay" to set the
switch-off delay:
0~255s.
e. Select "Language" to switch between
Chinese and English.
f.
Select "About" to check the device
version.
3. Click on "Encryption":
Enter 6-digit encrypted password in the popup
dialog box to encrypt the tuned sound effect data.
The data including EQ frequency, Q value and
gain, delay, channel volume and phase, etc. can
be encrypted.
Only the single set of sound effect data being
used now will be encrypted, rather than all the
data in the device. The encrypted sound effect
data can be saved as a pre-set sound effect or
computer file.
The encrypted data can be decrypted by
clicking on "Decryption" and entering the correct
password. On the decryption interface, click on
"Clear data" to decrypt the encryption status with
just one key and restore the data to the factory
default status.
Sound source selection
6
1.
Master sound source: click on the right key
of the master sound source and select the
master sound source in the popup window:
high level, blue tooth or low level.
2. Auxiliary sound source (sound mixing):
a 、 Click on the right key of the auxiliary
sound source and select the auxiliary
sound source in the popup window: high
level, blue tooth, low level or close.
b 、 The higher the attenuation of master
sound source, the lower the master
volume is. The tunable values are 0%,
30%, 50%, 80% or 100%.
* If the current sound source mode is
selected, this mode cannot be
superimposed any more. Otherwise, the
auxiliary sound source will be invalid.
Master sound source
Master volume setting
The left mouse button can be pressed on to
drag the volume fader left or right or the mouse
wheel can be scrolled to adjust the master volume.
The volume adjusting range is 0~35 and the default
is 27. Click on the Master volume speaker key [
to mute the master volume [
cancel the mute (the mute mode will be cancelled
automatically if the master volume is adjusted).
Sound effect setting
There are memories to save 6 sets of preset
sound effects in the device. Click on the Call key
[
] or Save key [
sound effect data.
Channel type, mute and debugging
Auxiliary sound
source
]. Click again to
] to select the 6 sets of
]
Advertisement
Table of Contents
