Advertisement
1. If you have a 4-wheel-drive model, insert the grommet
into the right PTO guard
Figure 7
1. Bolt (5/16 x 1/2 inch)
2. Washer (3/8 inch)
3. Grommet (4-wheel-drive
only)
2. Attach the front of the right PTO guard to the right
side of the machine using 2 bolts (3/8 x 7/8 inch),
2 washers (7/16 inch), and 2 locknuts (3/8 inch) as
shown in
Figure
7.
3. Attach the rear of the right PTO guard to the machine
using a bolt (5/16 x 1/2 inch) and washer (3/8 inch) as
shown in
Figure
7.
4. If you have a 4-wheel-drive model, route the steering
hoses through the grommet installed in step 1.
(Figure
7).
4. Washer (7/16 inch)
5. Locknut (3/8 inch)
6. Bolt (5/16 x 3/4 inch)
5. Attach the front of the left PTO guard to the left side of
the machine using 2 bolts (5/16 x 3/4 inch), 2 washers
(3/8 inch), and 2 nuts (5/16 inch) as shown in
1. Washer (3/8 inch)
2. Bolt (5/16 x 3/4 inch)
3. Nut (5/16 inch)
6. Attach the rear of the left PTO guard to the machine
using a bolt (5/16 x 1/2 inch) and washer (3/8 inch) as
shown in
Figure
7. Apply decal 133-6376 to the toolbox cover
1. Decal
7
Figure 8
4. Bolt (5/16 x 1/2 inch)
5. Washer (3/8 inch)
8.
Figure 9
Figure
8.
(Figure
9).
Advertisement
