To Select A Drawbar Organ Tone; To Edit A Drawbar Organ Tone - Casio CTK-691 User Manual

CTK691E01-01.book 23 ページ ２００３年９月２９日 月曜日 午後４時４７分

To select a drawbar organ tone

1.
Find the drawbar organ tone you want to use in
the tone list and note its tone number.
2.
Press the DRAWBAR ORGAN button.
This causes the drawbar organ tone selection
screen to appear.
1 Tone Number
2 Tone Name
3.
Use the number buttons to input the three digit
tone number for the tone you want to select.
Always input all three digits for the tone number, including
leading zeros (if any).
You can also increment the displayed tone number by
pressing [ + ] and decrement it by pressing [–].

To edit a drawbar organ tone

1.
Select the drawbar organ tone (000 to 049, 100
to 199) you want to edit.
2.
Use the [ ] and [ ] CURSOR buttons to display
the drawbar organ tone editing screen. Select the
parameter whose setting you want to change.
Example:
Selecting the "Ft16'" parameter
1 Parameter Setting
2 Parameter Name
705A-E-025A
Using the Drawbar Organ Mode
There are a total of 13 parameters. You can use
the [ ] and [ ] CURSOR buttons to cycle
through them. See "Parameter Details" on page
E-24 for more information.
While the "More?" screen is on the display, you
can advance to the synthesizer and DSP effect
editing screens by pressing the [
button or the [+] button.
3.
Use the [ ] and [
[ + ] and [–] buttons to change the setting of the
currently displayed parameter.
You can also change a parameter setting by
entering a value with the number buttons.
You can monitor the changes in a tone by playing
notes on the keyboard as you adjust parameter
settings.
Selecting a different tone after you edit parameters
replaces parameter settings with those of the newly
selected tone.
If you have drawbar organ tones assigned to more than
one channel, changing the drawbar organ tone setting for
one of the channels causes the same setting to be applied
to all of the other channels as well.
See "To save an edited drawbar organ tone" on page E-25
for information about saving your edits.
Editing Synthesizer Mode Parameters and
DSP Parameters of Drawbar Organ Tones
As with standard (non-drawbar) tones, you can edit the
Synthesizer Mode parameters and DSP parameters of
drawbar organ tones (See "Drawbar Organ Mode
Operational Flow" on page E-22).
1.
Use the [ ] and [
display "More?", and then press the [
CURSOR button.
This enters the Synthesizer Mode, which is
indicated by the pointer next to SYNTH on the
display screen.
For the remainder of this procedure, perform the
steps starting from step 3 under "Creating a User
Tone" on page E-47.
] CURSOR
] CURSOR buttons or the
] CURSOR buttons to
]
E-23