Bromine Generator Clear Water Plan - Cal Spas Portable Spas Owner's Manual

Cal spas portable spas owner's manual
Hide thumbs Also See for Portable Spas:
Table of Contents

Advertisement

Water Quality Maintenance
4.
Remove dirty filter from the spa and rinse off.
5.
Place your extra clean filter cartridge back into the
spa.
6.
Vacuum debris from the bottom of your spa with the
"Spa Vacuum".
Day Two (Friday)
1.
Test spa water using Chlorine Test Strips.

Bromine Generator Clear Water Plan

This plan and its chemical dosages are intended for spas equipped with the optional Cal Clarity Automatic Bromine
Generator. The chemical references are designed for Cal Spas chemicals only. Note: Following these instructions
is very important to ensure proper operation of your Cal Clarity Automatic Bromine Generator.
Start Up
1.
Clean surface of spa with Cal Spas "Multi-
Purpose Cleaner".
2.
Apply a protective coat of Cal Spas "Fast
Sheen" to the acrylic surface.
3.
Fill spa to proper water level with normal tap
water. (Do not use soft water.)
4.
Use Bromine Test Strip and balance the spa
water:
Adjust total alkalinity (acceptable range is
80-120 ppm)
Then adjust pH if necessary (between 7.2
to 7.8)
5.
Pour in 16 oz. of Cal Spas "Metal Protector"
to center of spa.
6.
Test for TDS (total dissolved solids, also known as conductivity) .
The ideal range is 50 to 300 ppm.
TDS / conductivity must be less than 500 to start with.
7.
Phosphate level should be below 200 ppb. Remove phosphates if necessary.
8.
Determine the gallons capacity of the spa. Be accurate as this determines the amount of TRU BLU that will be
added. Consult the Pre-Delivery Guide for spa gallons.
9.
Power up the spa and make sure all the spa's pumps are set to high speed. Turn the dial on the face of the Cal
Clarity Bromine Generator to "OFF".
10.
Sprinkle evenly over the surface of the spa, one 2 lb bottle of TRU BLU sodium bromide per 100 US gallons
(370 liters) of water. DO NOT ADD TOO MUCH!
Note: Each bottle of TRU BLU will raise TDS / conductivity amount approximately 500 ppm in a 500 gallon spa.
11.
Allow spa to run for 15 minutes so the TRU BLU can dissolve completely before proceeding to the next step.
Page 28
2.
Based on the Test Strip reading:
Adjust total alkalinity, then the pH if needed.
Add 1 tablespoon of Chlorine Granules (if
needed).
3.
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4.
Replace cover.
2009 Portable Spa Owner's Manual
LTR20091001, Rev. A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents