Agilent Technologies 8960 Series Reference Manual page 390

SYSTem:COMMunicate
SYSTem:COMMunicate:LAN[:SELF]:ADDRess
Function Sets/queries the test set's LAN IP address. The value of A is used to determine the subnet mask,
see "SYSTem:COMMunicate:LAN[:SELF]:SMASk" on page
If the LAN address is changed the subnet mask should be checked to insure that it is set to the
proper class for that LAN address.
Setting Range: 15 characters formatted as follows: A.B.C.D where A= 0 to 223 B,C,D = 0 to 255 (no
embedded spaces)
Query Range: 15 characters formatted as follows: A.B.C.D where A= 0 to 223 B,C,D = 0 to 255 (no
embedded spaces)
Factory 0.0.0.0 (this parameter is not affected by any reset operation and can only be changed by direct
setting user access)
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SYSTEM:COMMUNICATE:LAN:SELF:ADDRESS '130.015.156.255'"
!Sets the LAN IP address.
SYSTem:COMMunicate:LAN[:SELF]:DGATeway
Function Sets/queries the LAN IP router/gateway address for the test set.
Setting Range: 15 characters formatted as follows: A.B.C.D where A= 0 to 223 B,C,D = 0 to 255 (no
embedded spaces), blank field
Query Range: 15 characters formatted as follows: A.B.C.D where A,B,C,D = 0 to 255 (no embedded
spaces). blank field
Factory blank field, (this parameter is not affected by any reset operation)
setting
Requirements Test Application Revision: A.02.00 and above
Programming Example
OUTPUT 714;"SYSTEM:COMMUNICATE:LAN:SELF:DGATEWAY '130.2.6.200'"
390
S:\Hp8960\E1963A WCDMA\3.2 release\Reference Guide\Chapters\wcdma_hpib_system_communicate.fm
391.