Advertisement
Quick Links
Amerlite
(Concrete & Gunite) Installation Procedures
READ AND FOLLOW ALL INSTRUCTIONS
Section I.
General Information. ......................................................................................................... 2
Section II.
Concrete/Gunite Installation Instructions. ......................................................................... 3
For use with Pentair Pool Products wet niche light fixtures 783XXX, 784XXX, 788XXX, and 789XXX.
This niche - fixture housing must be installed by a licensed or certified electrician in accordance with
the National Electrical Code and all applicable local codes and ordinances. Improper installation will
create an electrical hazard which could result in death or serious injury to pool users, installers or
others due to electrical shock, and may also cause damage to property. Read and follow the specific
instructions below.
Before installing this product, read and follow all warning notices and instructions accompanying this niche. Failure to
follow safety warnings and instructions can result in severe injury, death, and property damage.
Call (800) 831-7133 for additional free copies of these instructions.
Attention Installer.
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
Pentair Pool Products
1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151
10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400
Rev. A 5-7-01
™
/AmerQuartz
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Table of Contents
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION!
Important Notice
®
Stainless Steel Niche
NOTE
DANGER
WARNING
1
P/N 619365
Advertisement
Related Manuals for Pentair Amerlite
Summary of Contents for Pentair Amerlite
- Page 1 Section II. Concrete/Gunite Installation Instructions................3 NOTE For use with Pentair Pool Products wet niche light fixtures 783XXX, 784XXX, 788XXX, and 789XXX. DANGER RISK OF ELECTRICAL SHOCK OR ELECTROCUTION! This niche - fixture housing must be installed by a licensed or certified electrician in accordance with the National Electrical Code and all applicable local codes and ordinances.
- Page 2 5. The niche is properly electrically bonded and grounded via the NO. 8 AWG ground connector located at the rear of the niche; see Figure 1. C. Use only Pentair Pool Products lighting fixtures in this niche to ensure proper bonding and grounding connections. DANGER...
- Page 3 Finished concrete surface must be cut-back behind the niche flange. Finished area surrounding the niche must be flat and flush with the brass mounting ring on the front of the niche. This ensures a snug fit between light and wall. Amerlite/AmerQuartz Stainless Steel Niche, (fixture housing) for Gunite Installation For pilot screw...
- Page 4 Pentair Pool Products 1620 Hawkins Ave., Sanford, NC 27330 • (919) 774-4151 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 523-2400 P/N 619365 Rev. A 5-7-01...