Apollo Sl50; Apollo Sl60 - Garmin Waypoint Manager User Manual

"PASS" or "FAIL". If the message is "pass," continue. If
the message is "fail," try again. If the procedure continues
to "fail," call technical support.
8. You can now exit from Waypoint Manager.
9. Follow the directions shown on the Apollo screen.

Apollo SL50

1. The SL50 must be removed from the aircraft. Connect the
SL50 to the PC and power supply with the proper cable
harness. Power on the Apollo SL50.
2. Start Waypoint Manager.
3. Under the Databases menu item, select the "Send Database
to GPS Unit" option on the PC.
4. Press WPT. Turn the Large knob to the Database Update
page. Press ENT to enable updating. No controls may be
used until the update is complete.
5. Send the database to the Apollo. Follow the directions
shown on the Apollo screen.
6. The PC will read the database, wait for the Apollo to erase
the old database, then send the blocks of data. After the
data has been sent, the PC is finished, but the Apollo must
still verify the new database. The Apollo will display
"PASS" or "FAIL." If the message is "pass," continue. If
the message is "fail," try again. If the procedure continues
to "fail," call technical support.
7. You can now exit from Waypoint Manager.

Apollo SL60

1. The SL60 must be removed from the aircraft. Connect the
SL60 to the PC and power supply with the proper cable
harness. Power on the Apollo SL60.
2. Start Waypoint Manager.
3. Under the Databases menu item, select the "Send Database
to GPS Unit" option on the PC.