Connect The Apollo Gps Receiver; Install A New Database To Hard Drive - Garmin Waypoint Manager User Manual

Connect the
Apollo GPS
Receiver
1. Connect the serial data cable between your computer and
2. Turn on the Apollo GPS receiver.
3. Set your Apollo GPS receiver I/O setting to communicate
A selection of typical operations that you may use on a frequent
basis are described in summarized form in the following steps.
For more detailed information, see the Reference section for
each topic.
Install A New
Database to
Hard Drive
1. Insert the floppy disk with your new Apollo database disk
2. Click on the Databases menu item. Select "Install
3. The "Choose Path" dialogue box will show floppy drive A:\
4. After the file has been copied to your hard drive, click on
5. In the "Open" dialogue box, select the appropriate file from
Connect and turn on your GPS receiver. You can also first
start your Waypoint Manager software in your personal
computer, if you wish.
the Apollo GPS receiver. If you have a 360 GPS receiver
installed in an aircraft, you may use a laptop to connect to
the installed receiver.
with a PC (refer to your Apollo GPS User's Guide). See
the section on serial ports on page 38.
Your Waypoint Manager program will allow you to easily
update the database in your Apollo GPS receiver.
into the floppy drive on your computer.
Databases to Hard Drive."
as the default drive. Select the appropriate drive letter if
your floppy drive has a different letter. Click on "OK."
the Databases menu item. Select "Send Database to GPS
Unit..."
the displayed list. Now, press "OK." The transfer will take
several minutes.