Apollo Gps Serial Port Selections For Pc Interface; Apollo 920; Apollo 360 Gps; Apollo Precedus - Garmin Waypoint Manager User Manual

Apollo GPS
Serial Port
Selections
for PC
Interface

Apollo 920

Using the serial outputs selection from the main menu on the
Apollo 920, select the "none" setting and press ENTER.

Apollo 360 GPS

Using the Serial Outputs selection from the main menu on the
Apollo 360, select the "PC [R/T]" setting for port 2 and press
ENTER.

Apollo Precedus

Using the serial outputs selection from the main menu on the
Apollo Precedus, select the "none" setting and press ENTER.

Apollo SL50/60

No special setup required.
Apollo GPS
Database
Update
Operation

Apollo 360, 920, and Precedus

1. Power on the Apollo. (no special key sequence is needed)
2. Make sure the Apollo is set up to communicate with the PC.
3. Start Waypoint Manager.
4. Under the Databases menu item, select the "Send Database
6. Send the database to the Apollo.
7. The PC will read the database, wait for the Apollo to erase
The serial port selection for the following units is described
below.
Summaries of the database update operation for sending a
database to your Apollo GPS are provided below for
selected products. You must install the database onto your
hard drive first (see page 20).
(Not For Application Or Boot Software!)
to GPS Unit" option on the PC.
the old database, then send the blocks of data. After the
data has been sent, the PC is finished, but the Apollo must
still verify the new database. The Apollo will display