Tips, Controls And General Info - Jeep COMPASS Owner's Handbook Manual

TIPS, CONTROLS AND
GENERAL INFO
479) 480)
167) 168)
ROAD SAFETY
Learn how to use the various system
functions before setting off.
Read the instructions for the system
carefully before starting to drive.
RECEPTION CONDITIONS
Reception conditions change constantly
while driving. Reception may be
interfered with by the presence of
mountains, buildings or bridges,
especially when you are far away from
the broadcaster.
WARNING The volume may be increased
when receiving traffic information and
news.
CARE AND MAINTENANCE
167) 169)
Observe the following precautions to
ensure the system is fully operational:
the display lens should not come into
contact with pointed or rigid objects
which could damage its surface; use a
soft, dry anti-static cloth to clean and do
not press;
do not use alcohol, petrol and derived
products to clean the display lens and
make sure that the Uconnect™ system is
switched off during cleaning;
370
prevent any liquid from entering the
system: this could damage it beyond
repair.
MULTIMEDIA DEVICES
WARNING Some multimedia players may
not be compatible with the Uconnect™
system.
Only use devices (e.g. USB flash
drives) from safe sources on the car.
Devices from unknown sources could
contain software infected by viruses
which, if installed on the car, could
increase the vulnerability of the car's
electric/electronic systems to hacking.
ANTI-THEFT PROTECTION
The system is equipped with an
anti-theft protection system based on
the exchange of information with the
electronic control unit (Body Computer)
on the vehicle.
This guarantees maximum safety and
prevents the secret code from being
entered after the power supply has been
disconnected.
If the check has a positive outcome, the
system will start to operate, whereas if
the comparison codes are not the same
or if the electronic control unit (Body
Computer) is replaced, the system will
ask the user to enter the secret code
according to the procedure described in
the paragraph below.
Entering the secret code
When the system is switched on, if the
code is requested, the display will show
"Please enter Anti-Theft Code" followed
by the screen showing a keypad to enter
the secret code.
The secret code has four numbers from 0
to 9: to insert the code numbers, rotate
the BROWSE/ENTER dial and press to
confirm.
After entering the fourth digit, the
system begins operating.
If an incorrect code is entered, the
system displays "Incorrect Code" to notify
the user of the need to enter the correct
code.
After the 3 available attempts to enter
the code, the system displays "Incorrect
Code. Radio locked. Please wait for 30
minutes". After the text has disappeared
it is possible to start the code entering
procedure again.
Car radio passport
This document certifies ownership of the
system. The car radio passport shows the
system model, serial number and secret
code.
In case you lose the car radio passport,
please go to Jeep Dealership with an ID
and the car papers.
WARNING Keep the car radio passport
in a safe place so that you can give the
information to the relevant authorities if
the system is stolen.