Cleaning - DeWalt DW168F Manual

Cleaning

waRnIng: Always wear certified safety equipment: ANSI Z87.1 eye protection (CAN/CSA
Z94.3) with side shields when using compressed air.
CaUtIon: Commercially-available chemical cleaners are very caustic. These cleaners may
damage plastic parts such as O-rings, floats and float valve seats. Check the container for
instructions.
Do not use these products if in doubt.
CaUtIon: Using high air pressure may cause damage to the carburetor, only use low air pres-
sure settings when cleaning passages and ports.
CaRBuREToR
1. Clean the carburetor body
with solvent.
2. Use low air pressure and
clean the following parts and
passages.
• Internal or external vent
port (J4)
• Pilot screw hole (K4)
• Pilot jet hole (L4)
• Pilot air jet (R2, M3)
• Main jet (I4)
• Transition ports (M4)
• Pilot outlet (N4)
K4
m4
N4
J4
ENGINE bLOCK SIDE
L4
R2, m3
AIR CLEANER SIDE
I4
J4
34