Carburetor - DeWalt DW168F Manual

Carburetor

DIsassEMBly
R1. Governor rod
S1. Governor spring
T1. fuel line
U1. Spark plug wire
V1. Insulator plate (if equipped)
W1. Carburetor gaskets (3)
X1. Manifold gasket
Y1. Choke lever
Z1. Carburetor
A2. Throttle lever
b2. Carburetor bowl drain bolt
C2. Air cleaner gasket
BEFoRE DIsassEMBly:
• Drain gasoline from gas tank before removing. Loosen the
carburetor bowl drain bolt (B2, F3, K2) and drain the carburetor
and gas tank completely.
• Disconnect the governor spring (S1).
waRnIng: Risk of explosion. Spilled gas o line and it's vapors
can be come ignited from sparks from smoking products, electrical
arcing, exhaust, flame, gas es and hot engine components such as
the muffler. Make sure there are no sources of ignition, such as
smoking products near servicing location. Wipe any fuel spillage
from engine.
waRnIng: Risk of explosion or fire. Gasoline vapor is highly
flammable. Refuel outdoors only in well-ventilated areas. Do not refuel
or check gasoline level while the engine is running. Do not store, spill
or use gasoline near an open flame, a source of sparks (such as
welding), or near operating electrical equipment.
U1
V1
X1
31
With the governor spring (S1)
unhooked, pull the carburetor out until
the groove in the throttle arm lines up
with the governor rod and then lift the rod
out. Assemble in reverse order.
T1
w1
Z1
b2
S1
R1
A2
Y1
C2