Garmin GPS 95 STD Personal Navigator Owner's Manual page 88

Garmin gps 95std: owners manual
Table of Contents

Advertisement

Need Altitude - The GPS 95 needs altitude to start and/or continue 2D
navigation. Press NAV and enter your current altitude. The altitude you enter
should be as accurate as possible. An inaccurate altitude will result in an
inaccurate position and navigation information.
No DGPS Position - An RTCM input has been selected, but not enough
DGPS data is available to calculate a corrected position.
No RTCM Input - An RTCM input has been selected, but no data is being
received or the input data is in the wrong format.
Osc Needs Adjustment - The GPS 95 has detected excessive drift in its
internal crystal oscillator which may result in longer acquisition time. The unit
should be taken to an authorized GARMIN service center as soon as
possible.
Poor GPS Coverage - The GPS 95 cannot acquire sufficient satellites
necessary to provide navigation.
Pwr Down and Re-init - The GPS 95 is unable to compute a position due
to abnormal satellite conditions. Power down the unit and verify that the
position on the Position Page is within a few degrees of your actual position.
Prox Alarm ____ - Your craft has penetrated the alarm circle of a proximity
waypoint.
Proximity List Full - An attempt has been made to add more than nine
waypoints to the proximity list. The GPS 95 will not allow more than nine
proximity waypoints.
Proximity Overlap - The circles defined by two proximity waypoints overlay.
When entering the area of the overlap, the GPS 95 will alert you of the closest
proximity waypoint, but not both. You should be certain this condition is
desirable.
Proximity Waypoint - An attempt has been made to delete a waypoint for
which a proximity alarm has been defined. You must remove the waypoint
from the proximity list before the waypoint can be deleted.
Received Invalid Wpt - A waypoint was received in an upload/transfer
operation that has an invalid identifier or position.
Receiver Failed - The GPS 95 has detected a failure in the receiver
hardware. If the message persists, the GPS 95 is unusable and should be
taken to an authorized GARMIN service center.
A-2

Advertisement

Table of Contents
loading

Table of Contents