Garmin Edge 205 Quick Reference Manual

Getting Started

power
1
• Press and hold to turn unit on/off.
• Press to turn backlight on/off.
mode
2
• Press to switch modes.
• Press to return to the previous page.
reset/lap
3
• Press and hold to reset the timer.
• Press to create a new lap.
start/stop
4
Press to start/stop the timer.
up/down
5
• Press to highlight options.
• Press to scroll through menus and data fields.
• Press to adjust contrast when on the Satellite page.
6
enter
Press to select options and to acknowledge messages.
Note:
If the Edge locks up, press
to reset the unit.
➋
Mount the Edge
You can install the bike mount to the stem or handlebars. The stem
installation (shown here) provides a more sturdy location. Make sure
that the Edge is facing up for the best GPS reception.
To install the Edge on your bike stem:
1. Place the wedge on the bike stem, and then place the bike
mount on the wedge. Make sure the release lever is on the left.
For horizontal bars:
mount, turn it 90 degrees, and replace. Continue with step 2.
For bars with a diameter less than 1 in (25.4 mm):
the additional rubber pad under the bike mount to increase the
diameter of the bar. The rubber pad also keeps the mount from
slipping. Continue with step 2.
➌
Configure the Edge
When you first turn on your Edge, the following setup screens appear.
Follow the on-screen instructions.
To configure your Edge:
1
2
3
mode reset/lap
and simultaneously
Separate and remove the top part of the
➊

Charge the Battery

1. On the back of the Edge, pull up the weather cap from the
mini-USB port. Make sure that this area is completely dry to
prevent corrosion.
2. Plug the mini-USB end of the charger into the mini-USB port on
the unit.
3. Plug the A/C charger into a standard wall outlet. Charge the
Edge for at least 3 hours before using. When the battery is
6
5
completely charged, it can run for approximately 12 hours
before recharging.
4
mini-USB port under
weather cap
2. Attach the bike mount securely using two cable ties.
Note:
of the bike mount.
3. Align the Edge with the bike mount so that the unit is vertical.
4. Slide the unit left until it snaps into place.
Place
To release the unit:
Press down on the release lever, and slide the unit to the right.
Make sure the cable ties are threaded through both parts