Coffee Measure - Gaggia D90 Evolution Operating Instructions Manual

7 - FUNCTION / USE AND
PROGRAMMING
INTRODUCTION
The programming software permits the
checking of the following operations:
- handling of 2-3 coffee units
- simultaneous function of both coffee
and tea units
- volumetric check on coffee measures
- timed tea measure check
- simulated measure programming
- filling level check and control
- system supervision through alarms
- continuos, delivery time-out and further
functions
- serial connection with accounting
devices
7.1

COFFEE MEASURE

PROGRAMMING
The measured amounts of coffee may be
modified (by means of volumetric checking)
and memorized as follows:
- press key T5 (of keyboard relative to
group 1) and keep pressed for over 5
seconds and check that all the
keyboard leds come on. In which case,
(by operating on the keyboard relative
to group 1) all the units will be
programmed, while by pressing key T5
of another unit, only the programming
of the unit on which one is operating is
possible.
IMPORTANT !! The settings made on unit
1 (operating on the first keyboard) will be
automatically copied on to all the other units.
Keyboard symbols:
T1 T2 T3
T1
Single espresso coffee
T2
Double espresso coffee
T3
Single long coffee
T4
Double long coffee
T5
Programming/continuos
T6
Tea (hot water)
32
T4 T5
T5
T6